Table of Contents
Advertisement
Installation
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Left / Right Hand Side
Rear
Assembly
•
This appliance is for professional use and is to be used by qualified persons
only.
•
Only qualified service persons are allowed to carry out installation and
servicing of this appliance.
This model is delivered completely assembled. Ensure that the
legs are securely attached.
NOTE:
• This appliance is fitted with adjustable feet to
enable it to be positioned securely and level on
uneven floors.
completion of the gas connection.
'Gas Connection Section'.
• This appliance can also be fitted with rear rollers to
enable the appliance to be easily moved for
positioning and cleaning purposes.
these rollers are supplied in the packaging, with
the appliance. See below for fitting instructions.
Optional Accessories (Refer to Replacement Parts
List)
• Plinth Kit.
instructions supplied with each kit.
Fitting Rear Rollers.
1.
Raise the appliance from the floor by approx.
75mm using suitable lifting equipment (i.e.
Palletiser / Forklift) to allow the rear
adjustable feet to be removed.
2.
Unscrew and remove both the rear
adjustable feet from the rear leg housings.
3.
Fit the rear roller to the rear leg housing and
align the screw hole in the side of the rear
leg housing with the threaded hole in the
rear roller.
4.
Secure the rear roller to the leg support with
the bolt supplied and tighten the bolt using a
10mm A/F spanner.
5.
Fit the second roller and tighten.
6.
Lower the appliance back to the floor and
adjust the front adjustable feet to level the
appliance.
Combustible Surface
50mm
50mm
C
This should be carried out on
For installation details, refer to the
Non Combustible Surface
:
AUTIO N
Appliance
Base
Refer to the
If desired,
Rear Leg
Housing
8
0mm
0mm
Locating Bolt
Adjustable
Rear Roller
Foot
Assy
Fig 1
Roller
Advertisement
Table of Contents
