Table of Contents
Advertisement
Conversion Procedure
Ensure that the appliance is isolated from the main gas and electricity supply
before commencing servicing.
NOTE:
• These conversions should only be carried out by qualified persons. All connections must
be checked for leaks before re-commissioning the appliance.
• Adjustment of components that have adjustments / settings sealed (e.g. paint sealed) can
only be adjusted in accordance with the following instructions and shall be re-sealed
before re-commissioning this appliance.
• For all relevant gas specifications, refer to the 'Gas Specifications' table at the end of this
section.
Gas Griddle
Main Burner Injectors
1.
Turn off the gas supply at the mains supply.
2.
Remove the grease tray from the front of the gas griddle,
taking care as the tray may be full of grease / oil.
3.
Remove the gas control knobs from the front control panel.
The control knobs are a push fit onto the shaft of the gas
control valves.
4.
Remove the front control panel by slackening the 2 screws
on the underside of the front control panel and remove the
panel from the front of the appliance.
5.
Unscrew and remove the main injectors (13mm - ½" A/F)
from the main burner end clamps.
6.
Determine the correct injector sizes for the corresponding
gas from the rating plate affixed to the lower right hand side
of the front sill.
7.
Replace with the correct size injectors. Refer to 'Gas
Specifications Table' for injector sizes.
8.
Ensure that the aeration sleeve is pushed fully 'IN' into the
burner and locked in position with the securing screw.
(Refer to Fig 7).
Pilot Burners
1.
To remove the pilot burner injector, disconnect and remove
the piezo igniter from the mounting bracket (this is
precautionary to prevent damage to the igniter). (Refer to
Fig 8).
2.
Slacken the gas supply tube at the gas control unit end of
the supply tube to allow the tube to be moved easily without
bending.
3.
Disconnect the gas supply tube from the base of the pilot
burner and withdraw the pilot injector from inside the pilot
burner. (Refer to Fig 8).
4.
Determine the correct injector size for the corresponding gas
from the rating plate affixed to the bulkhead by the manifold
test point.
5.
Re-connect the supply tube to the base of the pilot burner
and tighten the gas supply tube at the gas control unit end.
6.
Refit the piezo igniter to the mounting bracket.
7.
Re-connect the electrical connection to the piezo igniter, this
is a push fit connection.
Gas Conversion and Specifications
C
:
AUTIO N
23
A e r a t i o n
Sleeve
Pilot Injector Gas
Supply Pipe
Thermocouple
Piezo Igniter
Pilot Injector
Viewed from Inside the Burner Box
Main Injector
Fig 7
Piezo
Igniter
Fig 8
Thermocouple
Fig 9
Advertisement
Table of Contents
