Water-To-Syrup "Ratio" (Brix) Of Dispensed Product; Co2 Regulators; Adjusting Beaters Motors Currents; Programming Main Menu Selections Onto Message Display - Cornelius FCB OVERCOUNTER POST-MIX DISPENSER Service Manual

WATER-TO-SYRUP "RATIO" (BRIX) OF DISPENSED PRODUCT

Water-To-Syrup "Ratio" (BRIX) is the water-to-syrup "ratio" of the dispensed product. Adjust BRIX as instructed
in the SERVICE AND MAINTENANCE section.
CO REGULATORS
2
Primary CO Regulator.
2
The primary CO regulator (see Figure 2 and Table 8) regulates CO pressure to the soft drink tanks (also to
2 2
the bag-in-box syrup system if used) and also to the secondary CO regulators located inside the Unit. If neces-
2
sary to adjust the primary CO regulator, adjust as instructed in the SERVICE AND MAINTENANCE section.
2
Secondary CO Regulators.
2
The secondary CO regulators (see Figure 2 and 8) regulate CO pressure to the carbonator and product blend-
2 2
er tanks. If necessary to adjust secondary CO regulators, adjust as instructed in the SERVICE AND MAINTE-
2
NANCE section.

ADJUSTING BEATERS MOTORS CURRENTS

Beaters motors currents must be adjusted as instructed in THE INSTALLATION section.

PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY

The MAIN MENU SELECTIONS (see Table 4) may be brought up on the message display as instructed in the
INSTALLATION section.

SETTING ''CLOCK'' (TIME OF DAY)

NOTE: ''CLOCK'' (TIME OF DAY) must be programmed into Unit before ''DEFROST'' (AUTOMATIC),
''SLEEP'' (SLEEP TIME), and ''WAKE UP'' (WAKE UP TIME) can be programmed into the Unit.
Program ''CLOCK'' (TIME OF DAY) into Unit as instructed in the INSTALLATION section.

PROGRAMMING ''DEFROST'' (AUTOMATIC) SETTINGS INTO UNIT

The automatic defrost system may be programmed into the Unit to occur up to nine different times during a day
with a minimum of two hours between defrost time settings. Program automatic defrost time settings into the
Unit as instructed in the INSTALLATION section.

PROGRAMMING ''SLEEP'' (SLEEP TIME) INTO UNIT

''SLEEP'' (SLEEP TIME) may be programmed into Unit to occur any time of the day after the Unit automatic
defrost cycle has occurred. Unit will shut down (go into sleep time) and will not wake up (return to normal opera-
tion) until programmed ''WAKE UP'' (WAKE UP TIME) has occurred. Program ''SLEEP'' (SLEEP TIME) into
Unit as instructed in the INSTALLATION section.
36
2992