Linking; Dmx Mode; Dmx Addressing - ProLights Krypton 40G User Manual

14

3.7 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.8 DMX MODE

• Press the button MENU so many times until the display shows [001].
• Press ENTER button to confirm
• Press the buttons UP and DOWN to select the desired value [001 - 512];
• Press ENTER button to confirm

3.9 DMX ADDRESSING

To able to operate the KRYPTON with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the KRYPTON. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Start address
Number of
(example)
DMX channels
8 33
10 33
KRYPTON series
DMX Address Next possible start
occupied address for unit No. 1
33-40
33-42
Next possible start
address for unit No. 2
41
43
Next possible start
address for unit No. 3
49
53
57
63