Functions And Settings; Function; Basic - ProLights Krypton 40G User Manual

- 3 - FUNCTION AND SETTINGS

3.1 FUNCTION

Connect the supplied main cable to a socket (230 V~/50 Hz). Switch on the KRYPTON with the mains
switch (15). The red LED POWER (5) lights up as a power indication. To switch on the laser beam, connect
the supplied key to the lock of the switch (13) and turn the key to position ON.
When laser is powered on, the LED monitor on rear panel shows the current operating mode.
Then the unit is ready for operation and can be operated via a DMX controller or it independently per-
forms its show program in succession.
WARNING! This laser corresponds to the class 3B. Do not permit operation by persons not qualified for
operating the device.
Laser will be output from laser aperture in 5 seconds after the unit is powered on.
• Regular breaks during operation are essential to maximize the life of this device as it is not designed
for continual use.
• Do not switch the unit on and off in short time intervals.
• Always unplug the unit when it is not used for a longer time.
• In the event of serious operation problems, stop using the fixture and contact the manufacturer di-
rectly.

3.2 BASIC

Access control panel functions using the four panel buttons located directly underneath the LED display
(fig.3)
FUNC
Used to access the menu
or return a previous menu
option
KRYPTON series
UP
Used to change the mode
of operation or increase the
value of the function
DOWN
Used to change the mode
of operation or decrease the
value of the function
11
Fig.3
ENTER
Used to select and store the
current menu or confirm the
current function value or
option within a menu