Automatic; Sound Mode Sensitivity Setting; Master/Slave Mode - ProLights Krypton 40G User Manual

STANDALONE
This fixture has several options for operating without a DMX controller. Access these options via the con-
trol panel on the back of the fixture.

3.4 AUTOMATIC

This fixture has preprogrammed chases that may be triggered without a controller. Access these chases
via the control panel on the back of the fixture.
• Press FUNC button so many times until the display shows [Aut].
• Press ENTER button to confirm
MODEL KRYPTON 140RGY - KRYPTON 140GBC - KRYPTON 200RBP
• Press FUNC button so many times until the display shows [Aut].
• Press ENTER button to confirm
• Press FUNC button again to enter mode option. In the mode option setting, the stand alone laser show
that you are going to choose is flashing. Press UP/DOWN to change stand alone laser show, you will
have 4 different stand alone preprogrammed laser show [Aut- Au1 - Au2 - Au3]
• Press ENTER button to confirm

3.5 SOUND MODE SENSITIVITY SETTING

Where the function is described as a "Sound activated" function, the movements of the laser beam are
music-controlled via the microphone. For music control adjust the control SENSITIVITY for the microphone
sensitivity so that the dynamic power of the music will be reproduced in an optimum way by the movements
of the laser. When changing the pattern or the movement by a music signal, the LED (6) shortly lights up.
• Press the FUNC button so many times until the display shows [S6].
• Press UP and DOWN button to set microphone sensitivity. [S0] is no sound activated, from [S9], the sensi-
tivity level is going more sensitive.
• Press ENTER button to confirm
To enter in mode Sound Active:
• Press FUNC button so many times until the display shows [Sou].
• Press ENTER button to confirm
MODEL KRYPTON 140RGY - KRYPTON 140GBC - KRYPTON 200RBP
• Press FUNC button so many times until the display shows [Sou].
• Press ENTER button to confirm
• Press FUNC button again to enter mode option. In the mode option setting, the stand alone laser show
that you are going to choose is flashing. Press UP/DOWN to change stand alone laser show, you will
have 4 different stand alone preprogrammed laser show [ Sou - So1 - So2 - So3]
• Press ENTER button to confirm

3.6 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press FUNC button so many times until the display shows [Sla]
• Press ENTER button to confirm
• Select the desired operation mode (see section 3.4, 3.5)
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 15).
KRYPTON series
13