Advertisement
Signal Booster Specifications
Model Number
Connectors
Antenna Impedance
Frequency
Power output for single cell phone (dBm)
3
Power output for single cell phone (dBm)
3
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage
of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected
signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on
that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such
automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing
power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
Safety Guidelines
WARNING:
The Inside Antennas must have 18 inches of separation distance from all active users.
WARNING:
Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone.
WARNING:
Use only the power supply provided in this package. Use of a non-Wilson Electronics product may
damage your equipment.
WARNING:
The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less
than 150 degrees Fahrenheit). It is not intended for use in attics, vehicles or similar locations subject to
temperatures in excess of that range.
WARNING:
The Outside Antenna must be installed no higher than 10 meters (32'9") above ground.
RF SAFETY WARNING: Any antenna used with this device must be located at least 8 inches from all persons.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider
and have your provider's consent. Most wireless providers consent to the use of
signal boosters. Some providers may not consent to the use of this device on their
network. If you are unsure, contact your provider.
You MUST operate this device with approved antennas and cables as specified by
the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any
person.
You MUST cease operating this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate
for calls served by using this device.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Wilson Electronics could void the authority to operate this equipment.
Need help?
704-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 MHz Band 17
Uplink
25.7
700 MHz Band 17
Downlink
-4.3
www.WilsonElectronics.com
460008
SMA
50 Ohms
700 MHz Band 13
800 MHz
24.4
25.1
700 MHz Band 13
800 MHz
-4.1
-1.2
3 dB nominal
> 90 dB
5 V 2.5 A
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
1900 MHz
1700 MHz
25.2
23.8
1900 MHz
2100 MHz
4.0
5.6
7
Hide quick links:
Advertisement
