Powering Up The Router; Connecting The Router - Pirelli P.RG F4202N User Manual

POWERING UP THE
ROUTER
CONNECTING THE
ROUTER
© (2010) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
10
P.RG F4202N
To power up the Router:
Plug the power adapter into the power adapter port located on the rear of
1.
the Router
Plug the power adapter into a standard electrical wall socket
2.
Press the Power button located on the side of the Router
3.
Wait for the power LED to turn steady white
4.
The first step to install the router is to physically connect it to the fiber line and
then to connect it to a computer by means of an Ethernet connection.
To connect the fiber cable:
Connect one end of the fiber cable into the fiber port located on the rear
1.
panel of the Router.
Connect the other end of the fiber cable into the fiber socket
2.
To connect the Ethernet cable:
Connect one end of the Ethernet cable into one of the four Ethernet ports on
1.
the rear of the Router
Connect the other end of the Ethernet cable into the Ethernet Network card
2.
of your computer
Verify if the Ethernet Network card is configured as DHCP client, otherwise
3.
configure it to remain in the same local network of the router interface (see
chapter "Setting Up Your Computer")
HBK 939800036-A1 Hardware Installation