Lan Bridge >> Bridging - Pirelli P.RG F4202N User Manual

LAN BRIDGE >> BRIDGING
© (2010) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
32
P.RG F4202N
Routing Information Protocol (RIP). Select this check box to enable the Rout-
ing Information Protocol (RIP). RIP determines a route based on the smallest
hop count between source and destination. When RIP is enabled, select the fol-
lowing:
 Listen to RIP messages - select 'None', 'RIPv1', 'RIPv2' or 'RIPv1/2'.
 Send RIP messages - select 'None', 'RIPv1', 'RIPv2-broadcast' or 'RIPv2-
multicast'.
Routing Table. Allows you to add or modify routes when this device is active.
Use the 'New Route' button to add a route or edit existing routes.
This section allows you to specify the devices that you would like to join under
the network bridge. Click the 'Edit' icon on the VLAN column to assign the net-
work connections to specific virtual LANS.
LAN Bridge >> Bridging Panel
FIGURE 5.
HBK 939800036-A1 Network Connections Section