Troubleshooting; Basic Connection Checks; Browsing To The Router Configuration Screens - Pirelli P.RG F4202N User Manual

Fiber optic intergrated access device

Table of Contents

BASIC CONNECTION

CHECKS

BROWSING TO THE

ROUTER CONFIGURATION

SCREENS

Troubleshooting

 Check that the Router is connected to your computers and to the fiber line,

and that all the equipment is powered on. Check that the LAN Status (ac-

cording to your connection type) and WAN LEDs on the Router are illumi-

nated, and that any corresponding LEDs on the NIC are also illuminated.

 Ensure that the computers have completed their start-up procedure and are

ready for use. Some network interfaces may not be correctly initialized until

the start-up procedure has completed.

 If the link status LED does not illuminate for a port that is connected, check

that you do not have a faulty cable. Try a different cable.

If you have connected your Router and computers together but cannot browse

to the Router configuration screens, check the following:

 Confirm that the physical connection between your computer and the Router

is OK, and that the LAN Status LEDs on the Router and NIC are illuminated.

Some NICs do not have status LEDs, in which case a diagnostic program

may be available that can give you this information.

 Ensure that you have configured your computer as described in "Setting Up

Your Computer" on page 19. Restart your computer while it is connected to

the Router to ensure that your computer receives an IP address.

 When entering the address of the Router into your web browser, ensure that

you use the full URL including the "http://" prefix (e.g. http://192.168.1.1).

HBK 939800036-A1

135

Table of Contents

Show Quick Links

Table of Contents