Cameras Settings - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2
Contents

Cameras settings

Cameras PowerLine Frequency
The video system's camera is able to compensate for any flicker noise from the electrical
power supply (power line frequency anti-flickering). The camera also supports auto detection of
line frequency. Select the Auto option (default), or set this camera configuration based on your
power line frequency.
Requires user role: ADMIN
Value space: <Auto/50Hz/60Hz>
Auto: Allow the camera to detect the power frequency automatically.
50Hz: Use this value when the power line frequency is 50 Hz.
60Hz: Use this value when the power line frequency is 60 Hz.
Cameras PowerLine Frequency: Auto
Example:
Cameras Preset TriggerAutofocus
The current position (pan and tilt), zoom and focus are stored with a preset. Use this setting to
determine if the camera should refocus or use the focus value that is stored with the preset.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: Whether the camera refocuses or not when selecting a preset, depends on the
camera type.
Off: The focus value that is stored with the preset will be used. The camera will not refocus
when selecting a preset.
On: The camera will refocus when selecting a preset. The focus value that is stored with the
preset may be overridden.
Cameras Preset TriggerAutofocus: Auto
Example:
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface System settings System settings
Cameras Camera [1] Backlight
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN
Value space: <Off/On>
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Cameras Camera 1 Backlight: Off
Example:
Cameras Camera [1] Brightness Mode
Set the camera brightness mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set using
the Cameras Camera Brightness Level setting.
Cameras Camera 1 Brightness Mode: Auto
Example:
Cameras Camera [1] Brightness Level
Set the brightness level. Requires the Camera Brightness Mode to be set to Manual.
Requires user role: ADMIN
Value space: <1..31>
Range: Select a value from 1 to 31.
Cameras Camera 1 Brightness Level: 20
Example:
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
60
Administrator Guide
Setting passwords Appendices