Cameras Settings - Cisco Service Manual Service Manual

Cisco TelePresence SX20 Quick Set
Contents

Cameras settings

Cameras PowerLine Frequency
Applies to cameras supporting PowerLine frequency anti-flickering, i.e. PrecisionHD 1080p
cameras.
Requires user role: ADMIN
Value space: <50Hz/60Hz>
50Hz: Set to 50 Hz.
60Hz: Set to 60 Hz.
Example:
Cameras PowerLine Frequency: 50Hz
Cameras Camera [1..1] Backlight
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN
Value space: <Off/On>
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Example:
Cameras Camera 1 Backlight: Off
Cameras Camera [1..1] Brightness Mode
Set the camera brightness mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set using
the Cameras Camera Brightness Level setting.
Example:
Cameras Camera 1 Brightness Mode: Auto
D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013.
Introduction Web interface System settings System settings
Cameras Camera [1..1] Brightness Level
Set the brightness level. NOTE: Requires the Camera Brightness Mode to be set to Manual.
Requires user role: ADMIN
Value space: <1..31>
Range: Select a value from 1 to 31.
Example:
Cameras Camera 1 Brightness Level: 1
Cameras Camera [1..1] Flip
With Flip mode (vertical flip) you can flip the image upside down.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: When the camera is placed upside down the image is automatically flipped upside
down. This setting will only take effect for a camera that automatically detects which way it is
mounted.
Off: Display the video on screen the normal way.
On: When enabled the video on screen is flipped. This setting is used when a camera is
mounted upside down, but cannot automatically detect which way it is mounted.
Example:
Cameras Camera 1 Flip: Off
Cameras Camera [1..1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Example:
Cameras Camera 1 Focus Mode: Auto
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
51
Administrator Guide
Setting passwords Appendices