Placing A Call - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2
Contents

Placing a call

You can use the Call Control page to place a call.
Even if the web interface is used to initiate the call,
it is the video system (display, microphones and
loudspeakers) that is used for the call; it is not the PC
running the web interface.
Calling
You can call someone either by choosing a contact name in
the Local, Directory or Recents lists, or by typing a complete
URI or number in the Search or Dial field. Then click
the associated contact card.
Searching the contact lists
Enter one or more characters in the Search or Dial field.
Matching entries from the Local, Directory and Recents lists
will be listed as you type.
Select the correct entry in the list and click Call.
Calling more than one
A point-to-point video call (a call involving two parties only)
can be expanded to include one more participant on audio-
only.
If your system is using the optional built-in MultiSite feature,
up to four participants, yourself included, can join the video
call (conference). In addition, one more participant can join on
audio-only.
Follow the same procedure to call the next conference
participant as you did when calling the first participant.
Calling more than one using a conference bridge (CUCM ad
hoc conferencing or MultiWay) is not supported from the web
interface, even if it is supported by the video system itself.
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface Web interface
Navigate to: Call Control
Call in
Click a contact name, either in the
Local, Directory or Recents lists.
Then click
Alternatively, enter the complete URI
or number in the Search and Dial
field. Then click the
appears next to the URI or number.
System settings
Calling someone
Call in the contact card.
Call button that
17
Setting passwords
Holding and resuming Ending a call
If you want to terminate a
Use the button next
call or conference, click
to the participant's name
all. Confirm your choice in
to put him on hold.
the dialog that appears.
To resume the call,
To disconnect just one
use the button
participant in a conference,
that is present when a
click the
participant is on hold.
participant.
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
End
button for that