Controlling Your Camera - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2 Administrator Guide
Contents Introduction Web interface Web interface System settings Setting passwords Appendices

Controlling your camera

Navigate to: Call Control
When you control the video system's camera (pan, tilt, zoom)
from the Call Control page snapshots from the camera is
shown on the web interface.
As a consequence, a notification will be sent to the users
of the video system (shown on the main dispaly) that an
administrator is monitoring their video.
Camera presets
If one or more presets are defined,
click Presets... to open a list of
available presets.
Click a preset's name to move the
camera(s) to the preset position.
Click OK to close the window.
You cannot use the web interface to
Control the camera
define a preset; you should use the
1. Click the camera icon to open
video system's Touch user interface.
the camera control window.
2. Place the cursor in the image to
enable the controls.
If you are not allowed to control the
camera, the controls will not appear when
you place the cursor in the image.
3. Use the left and right arrows to pan the
camera; the up and down arrows to tilt it;
and + and - to zoom in and out.
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014. www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
20