Programming Components ''Diagnose'' (Diagnostic Mode) Into The Unit; Displaying ''Totals'' (Displayed Cycles And Hours Totals) Onto The Message Display; Programming Freeze Cylinders Beater "Motors" Into Unit Electronics; Programming Proper Refrigerant Type Into Unit Electronics - Cornelius FCB POST-MIX DISPENSER Installation & Service Manual

PROGRAMMING COMPONENTS ''DIAGNOSE'' (DIAGNOSTIC MODE) INTO THE UNIT

''DIAGNOSE'' (DIAGNOSTIC MODE) may be programmed into the Unit to check certain components for
operation. Program ''DIAGNOSE'' into the Unit and check components for proper operation as instructed in the
SERVICE AND MAINTENANCE section.
DISPLAYING ''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) ONTO THE
MESSAGE DISPLAY
''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) may be displayed on the message display as
instructed in the SERVICE AND MAINTENANCE section.

PROGRAMMING FREEZE CYLINDERS BEATER "MOTORS" INTO UNIT ELECTRONICS

IMPORTANT: Note in Table 6 "MOTOR SELECT" the number of freeze cylinders beater drive motors
Manufacturers that are listed. Your Unit was manufactured and equipped with freeze cylinders beater
drive motors from one of these Manufacturers. The beater motors were programmed at the factory to
match the Unit electronics. THE BEATER MOTORS PROGRAMMING MUST BE RE-CHECKED AT THE
TIME OF UNIT INSTALLATION as instructed in "PROGRAMMING FREEZE CYLINDERS BEATER
MOTORS INTO UNIT ELECTRONICS" in THE SERVICE AND MAINTENANCE section.

PROGRAMMING PROPER REFRIGERANT TYPE INTO UNIT ELECTRONICS

The Dispenser electronics must be programmed for the proper refrigeration pulse rate according to the type of
refrigerant gas that has been installed in the refrigeration system. Note Dispenser serial plate for the type of
refrigerant gas that has been installed, then proceed to SERVICE AND MAINTENANCE section for
programming instructions.

DISPLAYED ERROR CONDITIONS

Displayed error conditions, associated errors, and items affected by the errors are found in Table 9
DISPLAYED ERROR CONDITIONS.
INSTALLING CONTROL BOX COVER AND BACK, SIDES LOWER ACCESS,
AND TOP PANELS ON UNIT
1. Install upper electrical control box cover and secure with four screws.
2. Install back, sides, lower access, and top panels on Unit by reversing removal procedures.
2813
20