Table of Contents
Advertisement
PX865PE PRO II
IDE Primary/Secondary/Master/Slave PIO
The IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4) for each of the IDE
devices that the onboard IDE interface supports. Modes 0 to 4 will increase performance
incrementally. In Auto mode, the system automatically determines the best mode for each device.
Options: Auto (default)、Mode0、Mode1、Mode2、Mode3、Mode4.
IDE Primary / Secondary /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your
system. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
party IDE bus master driver). If your hard drive and your system software both support Ultra DMA
100, select "Auto" to enable BIOS support. Options: Auto (default)、Disabled
***OnChip Serial ATA Setting***
SATA Mode
When the "On-Chip Serial ATA" set to the "Combined Mode" and this item will allowsyou to select
the SATA Mode. Options: IDE (default)、RAID
On-Chip Serial ATA
This item allows you to enable or disabled the on-chip serial ATA function.
Options: Disabled (default)、Auto、Combined Mode、Enhanced Mode、SATA Only
Serial ATA Port0/ 1 Mode
This item allows you to select the Serial ATA device mode for port 0 & 1.
Options: Primary Master、Primary Slave、Secondary Master、Secondary Slave
Onboard Device
If you highlight the "INTEL OnChip PCI Device" label and then press the enter key, it will take you
to a submenu with the following options:
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: Enabled (default)、Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
36
Advertisement
Table of Contents
