Envelope Mode - Xerox Phaser 3020BI User Manual

4. Adjust the paper guide to the width of the stack of print
material. Push to move the guide toward the center of
the tray; squeeze to disengage the guide and move it to
the outer edge of the tray. Ensure you have not loaded
too much print media.
5. After loading paper in the paper tray, ensure you select
the Paper tab in the print driver to specify the correct
paper size and type. Not confirming the paper details
may result in printing delays.

Envelope Mode

1. Remove any curl on the envelope before loading it into the tray.
Notes:
• One envelope can be loaded. When printing envelopes and other special media, Manual
Feeder must be selected as the source in the print driver Paper tab.
• For more information on media specifications, refer to
2. Load the envelope short edge feed and with the flap
facing down as shown in the illustration.
3. Adjust the paper guide to the width of the print material.
4. After loading the media, ensure you select the Paper tab
in the print driver to specify the correct paper size and
type. For the source, you must select Manual Feeder. Not
confirming the paper details may result in printing
delays.
Loading Paper
Media Specifications.
Xerox® Phaser® 3020
User Guide
41