System Clock Commands; Access Point - 3Com 3CRWEASYA73 User Manual

show event-log
This command displays log messages stored in the access point's memory.
Syntax
show event-log
Command Mode
Exec
Example
Outdoor 11a Building to Building#show event-log
Mar 09 11:57:55 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:57:55 Information: 802.11g:Radio channel updated to 8
Mar 09 11:57:34 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:57:18 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:56:35 Information: 802.11a:11a Radio Interface Enabled
Mar 09 11:55:52 Information: SSH task: Set SSH server port to 22
Mar 09 11:55:52 Information: SSH task: Enable SSH server.
Mar 09 11:55:52 Information: Enable Telnet.
Mar 09 11:55:40 Information: 802.11a:11a Radio Interface Disabled
Mar 09 11:55:40 Information: 802.11a:Transmit Power set to QUARTER
Press <n> next. <p> previous. <a> abort. <y> continue to end :
Outdoor 11a Building to Building #configure
Enter configuration commands, one per line. End with CTRL/Z
Outdoor 11a Building to Building (config)#logging clear

System Clock Commands

These commands are used to configure SNTP and system clock settings on the

access point.

Table 14 System Clock Commands
Command Function
sntp-server ip Specifies one or more time servers
sntp-server enable Accepts time from the specified time servers
sntp-server date-time Manually sets the system date and time
sntp-server Sets the start and end dates for daylight savings time
daylight-saving
sntp-server timezone Sets the time zone for the access point's internal clock
show sntp Shows current SNTP configuration settings
6-37
Using the Command Line Interface
Mode
GC
GC
GC
GC
GC
Exec
Page
6-38
6-38
6-39
6-40
6-40
6-41