C
6: C
L
HAPTER
OMMAND
INE
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
Command Mode
Example
To specify the 10/100Base-TX network interface, enter the following command:
Outdoor 11a Building to Building (config)#interface ethernet
Outdoor 11a Building to Building (if-ethernet)#
dns server
This command specifies the address for the primary or secondary domain name
server to be used for name-to-address resolution.
Syntax
Default Setting
Command Mode
Command Usage
Example
This example specifies two domain-name servers.
Outdoor 11a Building to Building (if-ethernet)#dns primary-server
Outdoor 11a Building to Building (if-ethernet)#dns secondary-server
Outdoor 11a Building to Building (if-ethernet)#
I
NTERFACE
None
Global Configuration
dns primary-server <server-address>
dns secondary-server <server-address>
• primary-server - Primary server used for name resolution.
• secondary-server - Secondary server used for name resolution.
• server-address - IP address of domain-name server.
None
Global Configuration
The primary and secondary name servers are queried in sequence.
192.254.2.55
10.1.0.55
6-106