C
6: C
L
HAPTER
OMMAND
INE
Syntax
Default Setting
Command Mode
Example
This example globally enables the Spanning Tree Protocol.
Outdoor 11a Building to Building(config)bridge stp enable
Outdoor 11a Building to Building(config)
bridge stp forwarding-delay
Use this command to configure the spanning tree bridge forward time globally
for the wireless bridge. Use the no form to restore the default.
Syntax
Default Setting
Command Mode
Command Usage
I
NTERFACE
[no] bridge stp enable
Enabled
Global Configuration
bridge stp forwarding-delay <seconds>
no bridge stp forwarding-delay
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
15 seconds
Global Configuration
This command sets the maximum time (in seconds) the root device will wait
before changing states (i.e., discarding to learning to forwarding). This delay
is required because every device must receive information about topology
6-100