Show Hardware; System Logging Commands - 3Com 3CRWEASYA73 User Manual

C 6: C L
HAPTER OMMAND INE
SSH Server
SSH Server Port
Telnet Server
WEB Redirect
DHCP Relay
==============================================================
Version Information
=========================================
Version: v4.3.2.2
Date
=========================================
Outdoor 11a Building to Building #

show hardware

This command displays the hardware version of the system.
Command Mode
Example
Outdoor 11a Building to Building #show hardware
Hardware Version Information
===========================================
Hardware version R01
===========================================
Outdoor 11a Building to Building #

System Logging Commands

These commands are used to configure system logging on the access point.
Table 13 System Loggign Commands
Command
logging on
logging host
logging console
logging level
logging facility-type
logging clear
show logging
show event-log
I
NTERFACE
: ENABLED
: 22
: ENABLED
: DISABLED
: DISABLED
: Dec 20 2005, 18:38:12
Exec
Function
Controls logging of error messages
Adds a syslog server host IP address that will receive
logging messages
Initiates logging of error messages to the console
Defines the minimum severity level for event logging
Sets the facility type for remote logging of syslog
messages
Clears all log entries in access point memory
Displays the state of logging
Displays all log entries in access point memory
6-32
Mode Page
GC 6-33
GC 6-33
GC 6-34
GC 6-34
GC 6-35
GC 6-36
Exec 6-36
Exec 6-37