Using Can-Bus - Classe Audio CP-700 Owner's Manual

using CAN-Bus CAN-Bus is controlled via the touchscreen of any Delta series component. There
34
4 SSP-300 & 600 CAN-Bus Interface Box
Systems that include an SSP-600 or SSP-300 will also require an
SSP-300/600 CAN-Bus Interface Box. These are included with the products or
available free of charge from your nearest Classé Customer Support Centre
http://www.Classeaudio.com/support/service.htm
The diagrams below illustrate how to connect the CAN-Bus hardware.
Any combination of models in any order without SSP-300 or SSP-600.
Any combination of models in any order with SSP-300 or SSP-600.
NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.
is no master component, so Delta series systems where two or more units have
a touchscreen can be controlled through any of the touchscreens. However, it is
probably easiest to start using CAN-Bus through just one.
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT
CAN-BUS
IN OUT