Version Info; Sensors; Can-Bus; Features - Classe Audio CP-700 Owner's Manual

version info The version info button on the status screen takes you to the version
information screen, which displays information on various pieces of software
used by your CP-700. If you ever have occasion to call our technical support
people to ask a question not covered in this manual, they may want to know
precisely what version of software your unit is running. Having this information
available will help enable them to give you the best possible service.
sensors The sensors button on the status screen takes you to the sensors screen, which
displays information about several internal sensors within the CP-700. It is
unlikely you might ever need the sensor information, unless directed to do so by
a customer service representative at Classé in order to help troubleshoot some
unexpected problem.
CAN-Bus Classé's Controller Area Network, or CAN-Bus, opens the way to a new level
of interaction between our Delta range of amplifiers, preamps, processors
and source components. When the CP-700 is connected with CAN-Bus, the
different elements of a Delta series system are in constant communication,
creating a "global" network that delivers system wide status information and
shared operational features, all through the touchscreen display.
features CAN-Bus will allow a single Delta series touchscreen to:
• Display status information for every connected unit, including
• Create a "PlayLink" that allows an SSP or Preamp to automatically
• Adjust the global system brightness.
• Configure the entire system to go in and out of standby at the
• Mute any connected unit.

hardware setup 1

2
3
amplifiers which do not have a touchscreen display.
switch to the correct input when a Delta series source component
starts playback.
touch of a button and also bring individual components in and
out of standby.
Classé Delta Series Products
Two or more Classé Delta series products are required, at least one of which
must have a touchscreen display.
Category 5 Network Cables
These are ordinary network cables, commonly used for broadband Internet
connections. They should be typical "straight through" cables not the "crossed
over" type, and the total required will be one less than the total number of
Delta series components in your system.
CAN-Bus Terminator
A single CAN-Bus Terminator may be required. It is inserted into the
CAN-Bus OUT connector of the last component in the CAN-Bus
daisy chain. One is included in the box with your CP-700. They are also
available free of charge from your nearest Classé Customer Support Centre
http://www.Classeaudio.com/support/service.htm
33