Panasonic WJ-AV20 Operating Instructions Manual page 26

Remote Controller WV-CU20
ONE TOUCH DIAL
1 2 3
i
STEP1 STEP2
DIAL
1 2
MEMORY
4 5
7 8
0
ESC
MENU
TELE WIDE AF
26
6 Press the # (ALM MEMORY) button at the control site to
request an alarm video from the remote site.
VIDEO ALM ACK
4 5
AUTO/MANU
STEP3
CALL
3
REDIAL
6
9
DELETE
#
y
ALM MEMORY
AUDIO MUTE
o
ENTER
7 Select [YES] by pressing the direction button, then press the
NEAR
FAR ENTER button.
u
!0
8 Press the DIAL button for 2 seconds or more to terminate
communication.
9 Press the # (ALM MEMORY) button at the control site button.
Press the ENTER button to select video reproduction.
10
TRANSFER IMAGE FROM TRANSMITTER?
YES NO
←→:SELECT ENT:EXEC ESC:CLEAR
• The AV Codec at the remote site temporarily interrupts the real-time video
and audio transmission and begins to transmit an alarm video.
• The dialog appears on the monitor at the control site, and the video imme-
diately preceding the transfer is displayed as a still.
Audio and data transmission will be also interrupted.
• It takes about 150 seconds to transfer an alarm video (40 seconds at 128
kbps (2B)).
• After the transfer, real-time video at the remote site is displayed on the
monitor at the control site.
The alarm video cannot be played back during communication.
Terminate communication before attempting to play back the alarm video.
The dialog shown below appears on the monitor in the control site.
PLAYBACK IMAGE ?
YES NO
←→:SELECT ENT:EXEC ESC:CLEAR
The AV Codec will start reproducing the Select [YES} and you can press
the ENTER button to play back the alarm video previously stored in the
internal memory.
After the playback is completed, the AV Codec returns to a standby state.