System Configuration - Panasonic WJ-AV20 Operating Instructions Manual

SYSTEM CONFIGURATION

A standard system configuration for using the WJ-AV20 AV Codec is shown below.
• One AV-Codec is necessary for a remote site (transmitter) and another for a control site (receiver). The setup menu may
be used for setting change a transmitter to a receiver or vice versa. Before starting operation, check the settings.
• Cameras connected to the remote site can be switched as necessary to monitor them from the control site.
• An agreement is necessary for using ISDN lines.
• A DSU (Digital Service Unit, a line connecting unit) is also necessary.
• The optional WV-CU20E Remote Controller is necessary for system operation.
• In addition, sensors, personal computers, etc. may be added to configure a system suited to the environment.
Combination camera
Colour/black and white camera
Automatic fire alarm,
proximity sensor
Example of a system with 1 combination camera
and 4 colour or black and white cameras connected
In Case of Using a Panasonic Matrix Switcher with the AV Codec
Observe the following precautions when using a Panasonic matrix switcher connected to a remote site.
• To operate the matrix switcher and the devices connected to the matrix switcher, use the system controller (WV-
CU550A) exclusive to the matrix switcher.
• After communication starts, be sure to perform the log-in operation with the WV-CU550A before operating the matrix
switcher.
• Before terminating communication, be sure to perform the log-out operation with the WV-CU550A.
• If the matrix switcher is switched back on after communication is over, then the matrix switcher will be unable to be
operated again from the next call. In such a case, switch the system controller back on.
For the operating instructions for the matrix switcher and system controller, refer to the relevant manuals.
10
AV Codec
for remote site
REMOTE RING.VOL
LINE LINE
1 2
POWER
ON
OFF
AV Codec WJ–AV
Transmitter mode
ISDN
DSU
DSU
Video Monitor
AV Codec
for control site
REMOTE RING.VOL
LINE LINE
1 2
POWER
ON
OFF
AV Codec WJ–AV
Receiver mode
Remote Controller WV-CU20
ONE TOUCH DIAL
VIDEO ALM ACK
1 2 3 4 5
AUTO/MANU
STEP1 STEP2 STEP3
DIAL CALL
1 2 3
MEMORY REDIAL
4 5 6
7 8 9
DELETE
0 #
ALM MEMORY
ESC AUDIO MUTE
MENU ENTER
NEAR
TELE WIDE AF FAR
Controller