Wv-Cu20E Remote Controller (Option) - Panasonic WJ-AV20 Operating Instructions Manual

WV-CU20E Remote Controller (Option)

1
STEP 1
DIAL
#5
MEMORY
#4
$1
$0
ESC
$4
$3
MENU
$2
TELE
#1 One-touch Dial Buttons (ONE TOUCH DIAL, 1 - 5)
This button, in combination with the Dial button, is used
to call the destination that was previously assigned to
that button.
#2 Video Scanning Mode Button
(VIDEO AUTO/MANU, 4)
This button is used to toggle the scanning mode auto-
matically and manually.
#3 Alarm Acknowledge Button (ALM ACK, 5)
This button is used to acknowledge activated alarms.
#4 Quick Dial Button (MEMORY)
This button is used to select Quick (Short) Dial numbers
stored in the menu.
#5 Dial Button (DIAL)
This button is used to dial calls in combination with the
CALL button.
#6 Call Button (CALL)
This button is used call destinations.
#7 Redial Button (REDIAL)
This button is used to automatically redial the destina-
tion last called.
8
#1
Remote Controller WV-CU20
ONE TOUCH DIAL
VIDEO ALM ACK
2 3 4 5
AUTO/MANU
STEP 2 STEP 3
CALL
1 2 3
REDIAL
4 5 6
7 8 9
DELETE
#
0
ALM MEMORY
AUDIO MUTE
ENTER
WIDE AF NEAR FAR
#2
#3
%1
#6
%2
#7
#9
#8
$5
$6
$7
#8 Delete Button (DELETE)
This button is used to correct any numeric or alphabetic
input in the menu.
Pressing this button will delete the character positioned
immediately to the left of the cursor.
#9 # (Alarm Memory) Button (# ALM MEMORY)
This button is used to request an alarm video at the
destination site.
It is also used to play back alarm videos stored in the
internal memory.
$0
Button ( )
This button is used to toggle the camera image display
manually on the monitor with the view points assigned.
$1 Numeric Buttons (0 - 9)
These buttons are used for numeric input into the sys-
tem, including phone numbers, passwords, and cam-
era selection.
$2 Menu Button (MENU)
This button is used to open the setup menu on the mon-
itor screen.
Pressing it again will close the menu.
SER
NO.