Receiving Operation Dial-Up Standby - Panasonic WJ-AV20 Operating Instructions Manual

RECEIVING OPERATION DIAL-UP STANDBY

There are two ways of receiving calls: Automatic and man-
ual.
If automatic receiving mode has been set, then incoming
calls are automatically received by the AV Codec.
The operating procedures described below apply in cases
where the manual receiving mode has been set.
Remote Controller WV-CU20
ONE TOUCH DIAL
1 2 3
STEP1 STEP2
2
DIAL
1 2
MEMORY
4 5
4
7 8
0
ESC
MENU
TELE WIDE
AF
Note
The ringer sounds to indicate an
incoming call. The volume of the
ringer can be adjusted with the
ringer volume control knob. To
disable the ringer, set RINGER
on the RECEIVING REGI. setup
menu to OFF.
20
When there is an incoming call, the following screen appears
1
on the monitor (when receiving manually).
VIDEO ALM ACK
3
4 5
AUTO/MANU
STEP3
CALL
3
REDIAL
6
9
DELETE
#
ALM MEMORY
AUDIO MUTE
ENTER
NEAR FAR
2 Press the DIAL button to allow connection.
• Communication starts when the DIAL button is pressed. The video sent
• To reject the incoming call, press the ESC button.
Note
If Calling Number Check is set to ON in the system
setup process, then the telephone numbers of incom-
ing calls are checked. They are only connected if they
are registered in the directory.
Those telephone numbers not registered in the directo-
ry or not reported are automatically rejected.
• If the number is registered in the directory, then the quick dial
number and destination title are shown.
• If it is not registered, then the telephone number is shown.
RECEIVE A CALL?
NO.
YES NO
←→:SELECT ENT:EXEC DIAL:YES ESC:NO
from the calling site is displayed on the monitor. If audio is sent, it is also
output.
Incoming calls can also be allowed or rejected by selecting [YES] or [NO]
with the Direction buttons and pressing the ENTER button.
In case of an alarm dialing call, the ALARM DIAL display appears on the
monitor screen as shown below.
TITLE
ALARM DIAL 01/01/99 17:12:30 NO.2
01/01/99 17:13:05
ALARM2