Wan - NetComm 3G27WV-02 User Manual

WAN

The WAN page allows you to configure the optional WAN Ethernet port. Select the WAN connection type suitable for your
environment and configure parameters according to the selected connection type.
STATIC (fixed IP)
If your WAN connection uses a static IP address, please select "STATIC (fixed IP)" and fill in the required information in the fields
provided.
IP Address
Subnet Mask
Default Gateway
Primary/ Secondary DNS Server
MTU
MAC Clone
Status
MAC Address
NAT Configuration
Please refer to the WAN Failover Backup section on page 30 for information on configuring the WAN failover feature and
enabling the Failover notification function.
Click Apply to save any changes you make to the settings.
www.netcommwireless.com
Figure 21 - Advanced View - WAN - Static IP Settings
OPTION
Enter the static IP address that has been assigned to your connection by your
Internet Service Provider.
Enter the Subnet mask to be used with the IP address by your Internet Service
Provider.
Enter the WAN Gateway assigned to you by your Internet Service Provider.
Enter the DNS addresses assigned to you by your Internet Service Provider.
Enter the Maximum Transmission Unit which is the size of the largest data
packet that can be transmitted. In most cases the default unit of 1500 will
suffice.
Use the drop down list to enable or disable the MAC Clone function.
Input the MAC address of your computer here if your service provider only
permits computers with a certain MAC address to access the Internet. If you are
using the computer which was used to connect to the Internet via a cable
modem, you can simply press the 'Default' button. The router will then
automatically detect the MAC address of your computer and populate the MAC
address field with it.
Enable or disable Network Address Translation for this connection type.
Table 13 - Advanced View - WAN Settings - Static IP
DESCRIPTION
NetComm Wireless 3G27WV-02 User Guide
26