NetComm 3G27WV-02 User Manual page 34

Advanced Routing Settings
Static Routing allows computers that are connected to your NetComm Wireless 3G27WV-02 to communicate with computers
on another LAN segment which are connected to it via another router. To set a rule, you need to specify the following:
 Destination
 Range – Select from Host (255.255.255.255) or Net (and then enter the appropriate subnet mask)
Gateway

Interface

 Comment to identify the route entered (optional)
Dynamic Routing Settings
Dynamic Routing uses the RIP protocol to allow the NetComm Wireless 3G27WV-02 to adapt to changes in the network. RIP
enables the device to determine the best route for each packet based on the "hop count" or number of hops between Source
and Destination. To enable Dynamic Routing, select Enable from the drop box and click Apply.
www.netcommwireless.com
NetComm Wireless 3G27WV-02 User Guide
34