NetComm 3G27WV-02 User Manual page 66

Call Forwarding Busy
Call forwarding busy will divert all incoming calls to a phone number that you desire only if your telephone is busy on another call.
To enable Call Forwarding Busy, dial *67*<Directory Number># (Where directory number is the number you wish to forward calls
to) and hang up after you hear 2 low pitch beeps.
To disable Call Forwarding Busy, dial #67# and hang up after you hear 2 high pitch beeps.
To check the status of Call Forwarding Busy, dial *#67# or view the advanced status page of the management console.
 Call Forwarding Busy is disabled if you hear 2 high pitch beeps.
Call Forwarding Busy is enabled if you hear 2 low pitch beeps.

Call Forwarding Not Reachable
Call forwarding busy will divert all incoming calls to a phone number that you desire only if your telephone is unreachable by the
network.
To enable Call Forwarding Not Reachable dial *62*<Directory Number># (Where directory number is the number you wish to
forward calls to) and hang up after you hear 2 low pitch beeps.
To disable Call Forwarding Not Reachable, dial #62#, and hang up after you hear 2 high pitch beeps.
To check the status of Call Forwarding Not Reachable, dial *#62# or view the advanced status page of the management console.
Call Forwarding No Answer is disabled if you hear 2 high pitch beeps.

 Call Forwarding No Answer is enabled if you hear 2 low pitch beeps.
Conference Call
This can be achieved by performing a hook-flash and then by dialling the third party.
Wait for the third party to answer your call and then perform another hook-flash to conference all the parties together.
Please note: In order to activate a conference call, you will need to have originated both calls.
Troubleshooting
What do I do if I have no dial tone?
Please follow the procedure listed below:
1. Check to make sure the phone is plugged into your NetComm Wireless 3G27WV-02 on either Line 1 port or Line 2 port.
2. Check to make sure you are using the correct cable (Cat-3 UTP Telephone Cable with RJ-11 plugs).
3. Check to make sure the line light on the front panel of the NetComm Wireless 3G27WV-02 turns solid blue if you lift the
handset. Check to make sure the blue signal indication light on the front of the NetComm Wireless 3G27WV-02 is
blinking.
4. Check to make sure your SIM card is activated inserting it into your NetComm Wireless 3G27WV-02 properly.
5. Check and see if you get the dial tone after rebooting your NetComm Wireless 3G27WV-02.
I have noise interference during telephone calls. How can I fix this?
To resolve this issue, try the following:
 Verify that the RJ-11 cable is securely connected and not damaged.
Try to remove any telephone splitters from the connection between your phone and the NetComm Wireless

3G27WV-02.
Try rebooting your NetComm Wireless 3G27WV-02.

www.netcommwireless.com
NetComm Wireless 3G27WV-02 User Guide
66