Table of Contents
Advertisement
WAN - PPPoE (ADSL)
Most ADSL/ADSL2+ services use the PPP over Ethernet protocol. Use this setting on the router if you are utilising a fixed line
broadband service with a modem in bridge mode.
OPTION
PPPoE Mode
User Name/Password
Operation Mode
'Always on'
'On Demand'
'OFF'
Keep Alive Mode: Redial Period
On Demand Mode: Idle Time
MAC Clone
Status
MAC Address
NAT Configuration
Please refer to the WAN Failover Backup section on page 30 for information on configuring the WAN failover feature and
enabling the Failover notification function.
Click Apply to save the settings.
www.netcommwireless.com
Figure 23 - Advanced View - WAN - PPPoE Settings
Enter your PPPoE account username and password. This is your broadband username and password
that your Internet Service Provider assigned to you.
Keeps the Internet connection alive, does not disconnect.
Only connects to the Internet when there is a connection attempt.
Only connects to the Internet when the 'Connect' button on this page is pressed, and disconnects
when the 'Disconnect' button is pressed.
The time in seconds before the connection will attempt to be re-established when the Operation Mode
is set to Always On.
The time in minutes between internet connection attempts when the operation mode is set to "On
Demand".
Use the drop down list to enable or disable the MAC Clone function.
Input the MAC address of your computer here if your service provider only permits computers with a
certain MAC address to access the Internet. If you are using the computer which was used to connect
to the Internet via a cable modem, you can simply press the 'Default' button. The router will then
automatically detect the MAC address of your computer and populate the MAC address field with it.
Enable or disable Network Address Translation for this connection type.
Table 15 - Advanced View - WAN Settings - PPPoE
DESCRIPTION
NetComm Wireless 3G27WV-02 User Guide
28
Advertisement
Table of Contents
