Ricoh All in One Printer Operating Instructions Manual page 75

Message
Insufficient
memory. Reduce
the scanning ar-
ea.
Insufficient
memory. Reduce
the scanning ar-
ea.
Cannot find
"XXX" scanner
used for the
previous scan.
"YYY" will be
used instead.
(XXX and YYY indicate
a scanner name.)
Error has oc-
curred in the
scanner driver.
Cause
Scanner memory is insufficient.
When a paper misfeed occurs in
the machine during printing,
scanning cannot be performed.
• The main power switch of the
previously used scanner is not
set to "On".
• The machine is not connected
to the network correctly.
An error has occurred in the driver. • Check whether the network
When a Message is Displayed
Solution
• Reset the scan size.
• Lower the resolution.
• Set with no compression. See
TWAIN Driver help.
The problem may be due to the
following cause:
• The Relationship between the
Resolution and the Scanning
Area" chart in Help for half-
tone scanning might not al-
ways apply. Scanning cannot
be performed if large values
are set for brightness when
using halftone or high resolu-
tion.
After the misfed paper has been
removed, proceed with scanning.
• Check whether the main pow-
er switch of the scanner used
for the previous scan is turned
off.
• Check the previously used
scanner is connected to the
network correctly.
• Deactivate the personal fire-
wall of the client computer.
• Use an application such as tel-
net to make sure SNMPv1 or
SNMPv2 is set as the ma-
chine's protocol. See "Net-
work Settings", General
Settings Guide and "Using tel-
net", Network Guide.
• Select the scanner used for the
previous scan.
cable is connected correctly to
the client computer.
• Check whether the Ethernet
board of the client computer is
recognized correctly by Win-
dows.
• Check whether the client com-
puter can use the TCP/IP pro-
tocol.
5
69