Ricoh All in One Printer Operating Instructions Manual page 37

Problem
To cancel a Memory
Transmission.
To cancel an Immediate
Transmission.
Although a group spec-
ification was set for the
following, reception
was not possible.
Forwarding, Forward-
ing of Special Sender,
Email TX Result,rout-
ing email received via
SMTP.
❖ Reception
Problem
The machine failed to
print received fax docu-
ments.
The machine failed to
print received fax docu-
ments.
Receiving is impossible
though transmission is
possible.
❖ Printing
Problem
Printing does not start.
Printing does not start.
Print is slanted.
Print is slanted.
Print is slanted.
When You Cannot Send or Receive Fax Messages as Wanted
Cause
-
-
The number of specified destina-
tions exceeds the maximum
number that can be specified as a
group.
Cause
If this happened when the Re-
ceive File indicator was lit, low
paper may have caused printing
to stop.
When B is lit.
The ink has run out.
Cause
The cover of the One-Sheet By-
pass Tray or One-Sheet output
Tray is open.
There is paper left in the One-
Sheet output Tray.
The tray's side fences may not be
locked.
The paper is feeding in at a slant. Load the paper correctly. See p.71
The front cover is open.
Solution
If the original is being sent or if it
is in standby, press {Clear/Stop}
key. See "Canceling a Transmis-
sion", Facsimile Reference.
Press {Clear/Stop} key. See "Can-
celing a Transmission", Facsimile
Reference.
A maximum of 100 parties can be
specified for a group. Check if
there are over the specified num-
bers registered in the address
book. If a group was registered in
another group, transmission is
canceled but an error message
does not appear. See "Registering
a Names to a Group", General
Settings Guide.
Solution
Load paper into the tray. See
"Substitute Reception", Facsimile
Reference.
Load paper into the tray. See p.71
"Loading Paper".
Replace the print cartridge. See
p.91 "Replacing Print Cartridg-
es".
Solution
Check that the cover of One-Sheet
Bypass Tray or One-Sheet output
Tray is properly closed.
Remove any paper left in the
One-Sheet output Tray.
Check the side fences are locked.
See p.76 "Changing the Paper
Size".
"Loading Paper".
Make sure the right and lower
right covers are properly closed.
3
31