Ricoh All in One Printer Operating Instructions Manual page 51

Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Data-in lamp does not
blink or light up.
The status indicator of
the printer is red.
Updating destination
list. Reselect destina-
tion(s) or sender's name
later.
[List/Test Print] is disa-
bled.
Cause
If the machine is operating in an
extended wireless LAN SSID set-
tings are incorrect.
If the machine is operating in an
extended wireless LAN the re-
ceiver's MAC address may be
preventing communication with
the access point.
The extended wireless LAN has
not started.
Advanced encryption has been
set using the Extended Security
function.
The login user name, login pass-
word, or driver encryption key is
invalid.
If the data-in lamp is unlit or not
flashing even after performing
[Print], the machine has not re-
ceived the data.
The cause is displayed on the dis-
play of the control panel.
The destination list is being up-
dated from the network using
SmartDeviceMonitor for Admin.
A mechanical error might have
occurred.
When You Cannot Print
Solution
Check using the machine's dis-
play panel that the SSID is cor-
rectly set. See "Network Settings",
General Settings Guide.
Check access point settings when
in the infrastructure mode. De-
pending on the access point, cli-
ent access may be limited by
MAC address.
Also, check there are no problems
in transmission between access
point and wired clients, and be-
tween access point and wireless
clients.
Confirm the orange LED is lit,
and the green LED is lit or blinks
during transmission.
Check the settings of the Extend-
ed Security function with the ad-
ministrator.
Check the login user name, login
password, or driver encryption
key is correct.
• When the machine is connect-
ed to a computer via a cable,
check the computer print port
settings are correct. For how
to check the print port, see
"Confirming the Connection
Method", Printer Reference.
• When it is networked with a
computer, Contact the admin-
istrator.
Check the error message on the
display panel and take required
action. See p.41 "When a Message
Appears".
Wait until the message disap-
pears. Do not switch off the pow-
er while this message is
displayed. Depending on the
number of destinations to be up-
dated, there may be some delay
before you can resume operation.
Operations are not possible while
this message is displayed.
Contact your service representa-
tive. See "List/Test Print", Gener-
al Settings Guide.
4
45