Removing The Separators - Kyocera Mita Ecosys FS-1010 Service Manual

(1) Removing the separators

WARNING
The separation claws are extremely hot immediately after the printer was running.
Allow substantial period of time until it cools down.
1. Remove and split the fuser unit (See page 5-20).
2. Loosen the stopper screws 1.
3. Hold the separators 2 upright, and remove the separators 2 and separator springs 3.
FS-1010
Step 1
2
Figure 5-2-21 Removing the separators
Step 2
1
2
5-22
3