Cdrh Regulations (U.s.a.); Ozone Concentration; Optional Equipment; Important Note On The Interface Connectors - Kyocera Mita Ecosys FS-1010 Service Manual

(4) CDRH regulations (U.S.A.)

The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured after August 1, 1976. Compliance is mandatory for products marketed in
the United States. A label indicating compliance with the CDRH regulations must be attached to
laser products marketed in the United States.

(5) Ozone concentration

The printers generate ozone gas (O
an unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend
you not to install the printer in a confined area where ventilation is blocked.

(6) Optional equipment

The printer may be optionally installed with the following units:
• PF-17 Paper feeder (250 sheets)
• Serial interface board
• Network interface card
• Memory card

(7) Important note on the interface connectors

Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer.
For protection against static discharge which may be applied to the printer's internal electronics
through the interface connector(s), keep any interface connector which is not in use capped using
the protective cap supplied.
) which may concentrate in the place of installation and cause
3
1-9
FS-1010