Removing The Heater Lamp - Kyocera Mita Ecosys FS-1010 Service Manual

(2) Removing the heater lamp

WARNING The heater lamp is extremely hot immediately after the printer was running.
Allow substantial period of time until it cools down. Also, the heater lamp is
fragile: Handle it with great care.
CAUTION
The heater lamps are fragile. Use extreme care when handling not to drop or
break.
Do not directly touch on the heater lamp. Finger prints on the heater lamp's outer
surface can prevent proper fusing of toner on paper. When holding the heater
lamp, hold the ceramic parts of heater lamp at both ends.
When refitting the heater lamp, direct the short distance side from the projection
in the middle of the lamp facing the machine's left side.
1. Remove and split the fuser unit (See page 5-20).
2. Remove all (four) separators (See previous page).
3. Remove one screw 1, release the tension of lamp A holder 2.
4. Remove the heater lamp 3 form the lamp B holder 4.
5. Remove the heater lamp 3 from the heat roller 5.
2
Long
Machine
right side
1
Figure 5-2-22 Removing the heater lamp
Projection
Short
5-23
5
3
4
Machine
left side
FS-1010