Technical Specifications - Parmco PPOV-6S-10-1 Installation And Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

· Fasten the wires beneath the screw heads using the following colour scheme: Blue (N) Brown (L)

Yellow-Green

· Secure the supply cable in place with the clamp and close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardized plug corresponding to the load indicated on the data plate.

When connecting the cable directly to the mains, install an isolator. The isolator switch should be rated

according to the load and should comply with current regulations (the earth wire should not be interrupted

by the circuit breaker).

The supply cable should be positioned so that it does not reach a temperature of more than 50° C higher

than the room temperature, anywhere along its length, or should be protected by insulation sleeving with

an appropriate temperature rating.

Before switching the appliance on, please note:

· The electrical safety of this appliance can only be guaranteed if the cooker is correctly and efficiently

earthed, in compliance with local regulations on electrical safety. Always ensure that the earthing is

efficient; if you have any doubts call in a qualified electrician to check the system. The manufacturer

declines all responsibility for damage resulting from a system which has not been earthed properly.

· Check that the specifications indicated on the data plate (on the appliance and/or packaging)

corresponds to those of the electrical mains system of the home.

· Check that the electrical capacity of the system and sockets will support the maximum power of the

appliance, as indicated on the data plate. If you have any doubts, call in a qualified technician.

· If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a

qualified technician. Also ensure that the cross sections of the socket cables are suitable for the power

absorbed by the appliance. The use of adapters, multiple sockets and/or extensions, is not

recommended. All electrical work must comply with local regulation. The plug and socket must be

easily accessible.