To Replace The Dvd Drive; To Remove The Sas Disk Backplane - Sun Microsystems Fire T2000 Service Manual

To Replace the DVD Drive

▼
1. Slide the DVD into the front of the chassis until it mates with the connector in the
rear and the spring latch secures it.
2. Perform the procedures described in
page 103.

To Remove the SAS Disk Backplane

▼
1. Perform the procedures described in
Replacement" on page
2. Remove the DVD from the chassis.
See "To Remove the DVD Drive" on page
3. Remove all hard drives from the chassis.
See "To Remove a Hard Drive" on page
belongs.
4. Disconnect the SAS power cable from the power cable plug.
5. Make a note of which SAS data cable is plugged into which slot and disconnect
the four SAS data cables from the SAS disk backplane.
6. Remove the five screws that secure the SAS disk backplane to the chassis
( ).
FIGURE 4-26
SAS disk
backplane
Power cable
connector
l
Removing the SAS Disk Backplane
FIGURE 4-26
7. Remove the SAS disk backplane from the chassis and place it on an antistatic mat.
"Common Procedures for Finishing Up" on
"Common Procedures for Parts
67.
l
98.
63. Note the slot in which each drive
Chapter 4 Replacing Cold Swappable FRUs 99