Network Interface Settings - Sony SR-R1000 Operation Manual

Input example: SITE REPF FILE00000010.MXF 50 200 4 0
This transfers FILE00000010.MXF. The body consists
of 200 frames starting from frame 50, audio consists of
CH 1 to 4, and a metadata packet will not be added.
SITE MEID
Obtains the ID of a memory card inserted in this unit.
Command syntax: SITE MEID <SP> <memory card slot
number> <CRLF>
Input example: SITE MEID SRMemoryCard1

Network Interface Settings

IP addresses and other settings related to the network are
configured in the NETWORK SETUP menu of the
maintenance menu. This section provides a simple
overview. For details, see the Maintenance Manual.
To change the settings in the NETWORK SETUP
menu
1
While a normal menu (e.g., HOME) is displayed, press
the DIAG button while holding down the SFT button.
The MAINTENANCE INFORMATION menu
appears.
2
Press the [F8] (MAINTENANCE), [F9] (OTHERS
CHECK), and then [F3] (NETWORK SETUP)
buttons.
The menu display changes with each button, and the
NETWORK SETUP menu appears.
The current setting configurations appear on the menu
screen.
3
Press the parameter button of the setting you want to
change.
[F1] (NETWORK1 IP ADRS) IP address of Network 1
[F2] (NETWORK1 SUBNET): Subnet mask of
Network 1
[F3] (NETWORK2 IP ADRS): IP address of Network
2
[F4] (NETWORK2 SUBNET): Subnet mask of
Network 2
[F5] (NET1/2 GATEWAY): Default gateway of
Networks 1 and 2
[F6] (10G NETWORK IP ADRS): IP address of
optional 10Gbit network
[F7] (10G NETWORK SUBNET): Subnet mask of
optional 10Gbit network
[F8] (10G NETWORK GATEWAY): Default
gateway of optional 10Gbit network
[F9] (10G NETWORK MTU): MTU of optional
10Gbit network
4
Change the settings.
If you pressed [F1] to [F8] in step 3:
The display for the selected setting turns orange. Use
the numeric buttons to enter a value.
To move the cursor, use the left and right cursor
buttons (</,).
To confirm the setting, press the SET button and verify
that the value display turns white.
If you pressed [F9] in step 3:
The background of the value display for the [F9]
button turns orange. Use the up and down cursor
buttons (M/m) or the MULTI CONTROL knob to
change the value.
To confirm the setting, press the SET button and verify
that the value display turns to normal.
5
Press the [F10] (EXIT) button three times.
The MAINTENANCE INFORMATION menu
appears.
6
Press the button for a normal menu such as HOME to
close the maintenance menu.
69
FTP File Operations