Sony SR-R1000 Operation Manual page 61

Button Indication
[F9] MON MIX
[F10]
INT SG
ALT/[F2] NON-AUD
ALT/[F3] OUT PH
ALT/[F4] CH EXCHG
ALT/[F5] A/E IN
ALT/[F9] MON PH
ALT/ AUDIO SETTING
[F10]
[F1]
SCALE
[F10] EXIT
Setting
Sets the method for mixing the digital audio output via the AUDIO MONITOR
OUTPUT L/R connectors.
add: Simple addition
rms: Geometric mean
ave: Simple average
Selects the operation of the internal audio test signal generator.
off: Turns off operation of the audio test signal generator.
silence: Silence signal
1 kHz: 1 kHz sine wave (In this case, a 1 kHz, –20 dB sine wave is supplied to all
audio inputs.)
Selects a non-audio input signal. The setting is in units of stereo pairs. (see
page 48)
When this is set to other than "off," the setting of AUDIO INPUT select is disabled.
A/E: Selects the signal input to the DIGITAL I/O (AES/EBU) INPUT connector as a
data input.
HD SDI: Selects the signal input to the HD SDI INPUT A connector as a data input.
off: Treats input as audio. Select the input signal in AUD IN select.
Sets the output timing for the digital audio playback signal (SDI and AES/EBU only).
The 128 setting specifies the reference position.
A setting lower than 128 advances the output timing, and a setting higher than 128
delays the output timing.
(128 samples = approx. 2.7 ms, 1 sample = approx. 20 µs)
0 to 128 to 255 samples
Sets the relation between the digital signals (audio multiplexed with HD SDI output
and AES/EBU-format audio output) assigned to channels 1 to 16, and playback
track.
ch1 to ch16
Selects whether to pass the signals input to the DIGITAL AUDIO INPUT (AES/EBU)
connector through the sampling rate converter.
Auto: Passes the input signals through the sampling rate converter. In this case,
there are no limitations on input signals.
Vlock: Does not pass the input signals through the sampling rate converter. In this
case, the input signals need to be locked to video signals at 48 kHz. Noise will
occur if this condition is not met.
Selects video signals as the signals output timing standard for the AUDIO
MONITOR OUTPUT L/R connectors.
Default: Input signal for input ports
Output signal for output ports
Select: Monitor signal output to input ports' Multi Monitor connectors
Quad: Multi Monitor output "Quad" for output port D
LCD: Multi Monitor output "LCD" for output port D
Does not affect ALT/[F3] (OUT PH) in the AUDIO menu.
1)Audio signal is a few milliseconds late.
2)Can be set in the input port.
3)See [F8] (MULTI MONITOR) > [F1] (MODE) in the SETUP menu.
4)Output so that the average phase difference is kept to a minimum because LCD
signal images may be skipped/duplicated in frames.
Sets other settings.
Sets the mode for displaying digital audio levels.
Peak0: Displays minus audio levels with the maximum level set to 0 dB.
Ref0: Displays plus/minus audio levels with the reference level set to 0 dB.
Redisplays the previous menu.
1)
3)
3) 4)
Target
I/O
In
In
Out
Out
In
I/O
2)
I/O
I/O
–
61
Detailed Menu Description