Sony SR-R1000 Operation Manual page 18

e DIGITAL AUDIO INPUT (AES/EBU) connector
Input the audio signals in AES/EBU format for channels 1
to 16.
HD/SD Output board (SRK-R202)
a SD/HD SDI OUT A/B connectors
Output two sets of SD SDI or HD SDI video/audio signals.
Only the A connector is enabled during SD SDI signal
output.
b SD/HD SDI MONITOR A/B/MULTI connectors
Output the output signals for MONITOR A/B connectors.
Superimpose and output time data signals when ALT/
[F10] (CHAR ON) in the TC menu is set to On.
Only the A connector is enabled during SD SDI signal
output.
The MULTI connector cannot be used if the board is not
connected to port D.
The signal selected by [F8] (MULTI MONITOR) > [F1]
(MODE) in the SETUP menu is output when the board is
connected to port D.
LCD menu
Content identical to the images displayed in the control
panel's color display is output.
B Remote input/output section
a REMOTE 1 to 4 (9-pin) connectors
To control the unit from an external device, connect it to
the external device with a remote control cable that has a
9-pin connector.
The Sony 9-pin VTR protocol, Sony 9-pin Disk protocol,
VDCP protocol and Odetics protocol are supported.
b VIDEO CONTROL connector
Currently cannot be used.
18
Connector Panel
Quad menu
Each port monitor screen is reduced to 1/4 size and the
video signals for the four side-by-side screens are output.
The screens are arranged as follows: port A - top-left; port
B - top-right; port C - bottom-left; port D - bottom-right.
Memo
• The signal format is 4:2:2, 1920 × 1080 and either 59i,
50i, 24PsF, or 23.98PsF.
• Audio is not output.
c TIME CODE OUT connector
Outputs the playback time code.
d DIGITAL AUDIO OUTPUT (AES/EBU)
connector
Output the audio signals in AES/EBU format for channels
1 to 16.
c REF. INPUT connectors and 75 Ω terminal switch
Input the reference video signal of the selected field
frequency. Input an HD tri-level SYNC signal or SD black
burst signal.
A loop-through connection is also possible. Set the 75 Ω
terminal switch to OFF if you are using a loop-through
connection, and set it to ON if you are not using a loop-
through connection.