To Add An Output Sequence; Other Programming Selections - Honeywell Xenon 1900 User Manual

To Add an Output Sequence

1. Scan the Enter Seq uence symbol (see
Sequence, page 4-27).
2. Code I.D.
On the
you want to apply the output sequence format. Locate the Hex value
for that symbology and scan the 2 digit hex value from the
Programming Chart (inside back cover).
3. Length
Specify what length (up to 9999 characters) of data output will be
acceptable for this symbology. Scan the four digit data length from the
Programming Chart. (Note: 50 characters is entered as 0050. 9999
is a universal number, indicating all lengths.) When calculating the
length, you must count any programmed prefixes, suffixes, or
formatted characters as part of the length (unless using 9999).
4. Character Match Sequences
On the
Hex value that represents the character(s) you want to match. Use
the Programming Chart to read the alphanumeric combination that
represents the ASCII characters. (99 is the Universal number,
indicating all characters.)
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or
Save to save your entries.

Other Programming Selections

• Discard
This exits without saving any Output Sequence changes.
4 - 24
Symbology Charts
ASCII Conversion Chart (Code Page
Require Output
on page A-1, find the symbology to which
1252), page A-4, find the