Using The Quick Arm; Disarming Your System - GE LCD Keypad User Manual

The [BYPASS] key will illuminate if any zone(s) are bypassed. If any
zone(s) have been bypassed previously by the user, the light(s)
corresponding to the bypassed zone(s) will illuminate, alerting the user
that a zone(s) may be unprotected and can be faulted without an alarm.
To toggle between the STAY and NIGHT mode, double press the key
To upgrade from the STAY or NIGHT mode to the AWAY mode, double press
Once the AWAY mode is activated, the system must be disarmed to revert to
the STAY or NIGHT mode.

USING THE QUICK ARM

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system in the AWAY / STAY / NIGHT modes by pressing the
corresponding [AWAY], [STAY], [NIGHT] key twice. This feature is used for
ARMING ONLY, and will not disarm the security system. This is ideal for a maid or
baby sitter, etc.
CHANGING MODES WHILE YOUR SYSTEM IS ARMED (Optional)
Double pressing the [AWAY], [STAY], or [NIGHT] key will change to the
corresponding mode. Once the AWAY mode is entered, the system must be
disarmed to change modes.

DISARMING YOUR SYSTEM

When you enter the protected area through one of the designated Entry/Exit doors,
the keypad control will sound a continuous tone for the duration of the entry delay
time, or until you enter a valid code.
1. Enter a valid user code.
2. The currently armed key [AWAY],
[STAY], or [NIGHT] will go off and the tone will stop. The security system is
now DISARMED. If a valid code is not entered before the end of the entry
delay, an alarm will occur. NOTE: If the [AWAY], [STAY], or [NIGHT] keys
are all flashing during the entry delay, the alarm system has been
activated in your absence. Leave the building immediately and call your
alarm company and/or the police from a safe location.
LCD Keypad
corresponding to the mode you desire.
the [AWAY] key.
Type code to
Disarm
7