Table of Contents
Advertisement
Using the Quick Arm (optional)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm the security system in the
AWAY mode by pressing the [EXIT] key, or arm in the STAY mode by pressing the [STAY] key. This feature is used
for ARMING ONLY, and will not disarm the security system. This is ideal for a maid or baby sitter code, etc.
Changing modes while system armed
Pressing the [STAY] key will turn on/off (toggle) a delay on entry/exit doors and turn on/off (toggle) the instant icon.
(Optional) Press the [BYPASS] key at this time to turn on/off (toggle) all designated interior zones.
(Optional) When armed, pressing the [EXIT] key will start the exit delay, enabling you to leave the building.
The instant icon needs to be off at this time if you plan on re-entering the building; otherwise you will create an
alarm. You may restore an entry delay by pressing the [STAY] key again.
Disarming the system
When you enter the protected area through one of the designated Entry/Exit doors, the keypad control will sound a
continuous tone for the duration of the entry delay time, or until you enter a valid code. The armed icon will go off and
the tone will stop. The security system is now DISARMED. If a valid code is not entered before the end of the entry
delay, an alarm will occur. (NOTE: If the armed icon is flashing during the entry delay, the alarm system has been
activated in your absence. Leave the building immediately and call your alarm company and/or the police from a
safe location.)
CANCEL / ABORT feature (optional)
The cancel led will flash during an abort delay time. If a code is entered followed by the [CANCEL] key while this led
is flashing, all abortable reports will stop the communication process. Entering a code followed by the [CANCEL] key
during or after an alarm report to the central station will cause the cancel led to come on. It will stay on until the central
station has received the cancel report.
Bypassing zones
If you wish to bypass one or more zones, this must be done while the system is in the disarmed state. The following steps
are used for bypassing zones:
Step 1
Press the [BYPASS] key.
Step 2
Enter user code, if required (optional). The bypass led flashes.
Step 3
Enter 1 or 2 digits indicating the zone you wish to bypass, i.e. press the [1] key for zone 1, press [1]-[2] for
zone 12.
Step 4
Press the [BYPASS] key again.
Step 5
The corresponding zone icon will illuminate indicating the zone has been bypassed. Repeat steps 3 and 4 for
any other zone(s) that need to be bypassed.
Step 6
Press the [BYPASS] key again -or- press the [#] key to exit the Bypass Mode. The bypass led will stop
flashing upon exiting the Bypass Mode.
NX-1348E-ICON
IMPORTANT!
g
GE Interlogix
- 10 -
Hide quick links:
Advertisement
Table of Contents
