Using The Quick Arm (Optional; Changing Modes While System Is Armed; Disarming The System; Cancel / Abort Feature (Optional - GE NetworX NX-1500E User Manual

USING THE QUICK ARM (Optional, see page 1)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the
user to arm the security system in the AWAY mode by pressing the [EXIT]
key, or arm in the STAY mode by pressing the [STAY] key. This feature is
used for ARMING ONLY, and will not disarm the security system.
ideal for a maid or baby sitter code, etc.

CHANGING MODES WHILE SYSTEM IS ARMED

Pressing the [STAY] key will turn on/off (toggle) a delay on entry/exit
doors and turn on/off (toggle) the instant light.
(Optional) Press the [BYPASS] key at this time to turn on/off (toggle)
all designated interior zones.
(Optional)
delay, enabling you to leave the building.
The instant light needs to be off at this time if you plan on re-
entering the building; otherwise you will create an alarm. You may
restore an entry delay by pressing the [STAY] key again.

DISARMING THE SYSTEM

When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a continuous tone for the duration of
the entry delay time, or until you enter a valid code. The red armed light
will go off and the tone will stop. The security system is now DISARMED. If
a valid code is not entered before the end of the entry delay, an alarm will
occur. (NOTE:
delay, the alarm system has been activated in your absence. Leave
the building immediately and call your alarm company and/or the
police from a safe location.)
CANCEL / ABORT FEATURE (Optional, see page 1)
The cancel light will flash during an abort delay time. If a code is entered
followed by the [CANCEL] key while this light is flashing, all abortable
reports will stop the communication process. Entering a code followed by
the [CANCEL] key during or after an alarm report to the central station will
cause the cancel light to come on. It will stay on until the central station has
received the cancel report.
When armed, pressing the [EXIT] key will start the exit
IMPORTANT!
If the red armed light is flashing during the entry
Page 9
This is