GE LCD Keypad User Manual page 24

DISPLAY
Log Full
Open
Close
Exit Err
Rec Close
Autotest
Start Prog
End Prog
Start Dnld
End Dnld
Cancel
Gnd Flt
Man Test
Re-exit
Output Trip
Data Lost
Walk-test
End Test
Cross-Trip
Expansion
Event
Partial Arm
22
Log Full
Open
Close
Exit Error
Recent Close
Auto Test
Start
Programming
End
Programming
Start Download Download session is started.
End Download Download session is ended.
Cancel
Ground Fault
Manual Test
Re-Exit
Output Trip
Data Lost
Walk-Test
End Test
Cross Trip
Expansion
Event
Partial Arm
DESCRIPTION
The event log is full. Old events will be pushed
out as new ones enter the log.
Reports user number, date, time and partition of
opening.
Reports user number, date, time and partition of
closing.
Entry/Exit zone was faulted at the instant the
exit delay expired.
An alarm occurred within 5 minutes after the
control was armed.
Sending a communicator test at a specified
interval.
Local programming is started.
Local programming is ended.
System is disarmed and the Cancel button was
pressed within 5 minutes of an alarm.
A short to ground has been detected.
Bell and/or communicator test while system is in
disarmed condition.
The exit delay has been re-started without
disarming the system.
A trip has occurred on an expander auxiliary
output.
Communication of a signal has failed (log only
event).
A zone "Walk-Test" mode has been activated.
Test has been ended.
The first zone of a cross zone has been tripped
(log only).
An expansion module created an undefined
event.
Reports a closing in the stay mode.
LCD Keypad