Using The Quick Arm; Changing Modes While Your System Is Armed; Disarming Your System - GE NX-148E User Manual

USING THE QUICK ARM

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to
arm the security system in the AWAY mode by pressing the [EXIT] key. The system
can be quick armed in the STAY mode by pressing the [STAY] key. This feature is used
for ARMING ONLY, and will not disarm the security system. This is ideal for a maid or
baby sitter code, etc.

CHANGING MODES WHILE YOUR SYSTEM IS ARMED

Step 1 Pressing the [STAY] key will turn on/off (toggle) a delay on Entry/Exit doors.
The "Instant" message will toggle on the LCD display.
Step 2 (Optional, if programmed.) Press the [BYPASS] key at this time to turn on/off
(toggle) all designated interior zones. If all interior zones are not bypassed,
the stay light will extinguish.
Step 3 (Optional, if programmed.) When armed, pressing the [EXIT] key will start the
Exit delay, enabling you to leave the building.
An alarm will be created if the "Instant" message is ON at this time and you re-enter
the building. You may re-initiate an entry/exit delay by pressing the [STAY] key again.
The "Instant" message will disappear.

DISARMING YOUR SYSTEM

When you enter the protected area through one of the designated Entry/Exit doors,
the keypad control will sound a continuous tone for the duration of the entry delay
time, or until you enter a valid code.
Step 1 Enter a valid user code.
Step 2 The red armed light will go off and
the tone will stop. The security
system is now DISARMED. If a valid code is not entered before the end of the
entry delay, an alarm will occur. NOTE: If the red armed light is flashing
during the entry delay, the alarm system has been activated in your
absence. Leave the building immediately and call your alarm company
and/or the police from a safe location.
NX-148E LCD Keypad
IMPORTANT!
Type code to
Disarm
7