Advertisement
VR200 ROWER ASSEMBLY INSTRUCTIONS
STEP 1
Clear a 6.5' x 8' working space before unpacking your VR200
Rower.
STEP 2
Open the carton as shown in the diagram below.
NOTE: To protect the VR200 Rower while assembling we
suggest that you do not remove the protective Packing
Material until it is absolutely necessary.
STEP 3
a) Reverse the ALUMINUM BEAM [001] .
b) Remove 4 x BOLT [300] from SEAT [045] with the TOOL
provided.
c) Assemble the SEAT [045] and the ALUMINUM BEAM
[001] with 4X BOLT [300] .
CABLE TIE
TOOL
300
045
2
Assemble the STABILIZER - REAR [007] and the ALUMI-
NUM BEAM [001] with 4X BOLT [300] and 4X WASHER
[401] and REAR THREADED PLATE [007A] .
TOOL
007
007A
Assemble the ALI END CAP[116] and the ALUMINUM BEAM
[001] with BOLT [301] .
001
116
301
STEP 4
CABLE TIE
001
300
401
007A
STEP 5
001
STEP 6
Assemble the STABILIZER - FRONT [005] with 2 X BOLT
[306A] and 2 X NUT [201A] and 2 X WASHER [403] .
306A
002
306A
STEP 7
a) Push down the PIVOT LOCK BAR HANDLE[028A] and
then lift up the PIVOT BRACKET [003] until "CLICK" sound is
heard.
b) Assemble the TRANSPORTATION BRACKET [004A] and
the MAIN FRAME [002] with 2 X BOLT [305] and 2 X
WASHER [401] and 2 X NUT [200] .
003
002
028A
305
004A
401
200
201A
403
005
Advertisement
