Advertisement
VR200 ROWER ASSEMBLY INSTRUCTIONS
STEP 8
a) Remove 1 X NUT [200] and 1 X WASHER [401] from
RIGHT FOOT PEDAL [021] is marked "R" with the TOOL
provided.
b) Assemble the RIGHT FOOT PEDAL [021] to MAIN
FRAME [002] with same 1 X NUT [200] and 1 X WASHER
[401] ,Slide the RIGHT FOOT PEDAL BAR [012A] with 1X
WASHER [402] through MAIN FRAME [002] with 1 X NUT
[200] and 1 X WASHER [401] as shown in the diagram below
and tighten firmly.
c) Repeat procedure for Left side FOOT PEDAL [021]
marked "L"
002
021
402
012A
402
200
200
401
401
200
401
3
a) Remove 6 X BOLT [300] and 6 X WASHER [401] and 2 X
SEAT CARRIAGE STOPPER [124] and 2 X WASHER [402]
from PIVOT BRACKET [003].
b) Assemble the ALUMINUM BEAM [001] and the PIVOT
BRACKET [003] with same 6 X BOLT [300] and 6 X
WASHER [401] and 2 X WASHER [402] and 2 X SEAT
CARRIAGE STOPPER [124] .
NOTE: When assembling the ALUMINUM BEAM [001]
with the PIVOT BRACKET [003], make sure the HANDLE
[003A] is not touching the PIVOT BRACKET [003] in
order to avoid the HANDLE [003A] being scratched by
the ALUMINUM BEAM [001].
021
402 401
STEP 9
001
402
124
402
300
401
003
003A
002
STEP 10
a) Push down the PIVOT LOCK BAR HANDLE [028A] and
then put down the ALUMINUM BEAM [001]. Lift up the
ALUMINUM BEAM [001] by pulling up the PIVOT HANDLE
[003A] until "CLICK" sound is heard.
b) Assemble the COMPUTER [714] with Battery .
c) Trim the ALUMINUM BEAM [001] CABLE TIE .
001
028A
003A
714
CABLE TIE
Advertisement
